Vax VCC-07 User's Guide download pdf (Page 4)

3. How to Assemble

Fig.3/3

Fig.3/2

Fig.3/1

4 5

5. Accessories

The accessories can be attached directly to

the handle by removing the extension tube

and pushing in the desired accessory.

The accessories can also be attached to

the extension tube for extra reach. Remove

the combination ﬂoor head and push on the

desired accessory.

Crevice Tool: for crevices, corners, cracks,

sills, etc.

Dusting brush: for delicate surfaces.

6. Dirt Container:

Removal and Replacement

IMPORTANT: Always unplug the

vacuum cleaner from the electrical

outlet before removing the dust bag.

IMPORTANT: DO NOT use the

vacuum cleaner without ALL of the

ﬁlters in place.

Dust Bag Replacement

1. Turn off the vacuum cleaner and unplug it

from the mains. Remove the hose. Unclip

the retainer clip on the top of the unit

and lift up to gain access to the dust bag

compartment. (Fig.6/1)

Fig.6/1

Fig.6/2

2. Push the extension tube on to the end of

the handle. The extension tubes can be

used together to lengthen or shortened by

using one section of the extension tube as

required.(Fig.3/2).

1. Insert the ﬂexible hose into the inlet on the

main body of the vacuum cleaner. Turn the

hose clockwise until it cannot be turned

any further (Fig.3/1).

3. Fit the combination ﬂoor head by pushing

onto the extension tube. (Fig.3/3).

4. How to Operate

Fully unwind the power cord.

On/Off Button

Insert the power plug into the electrical outlet.

Ensure the vacuum cleaner is switched off.

Press the on/off button located at the rear

of the machine to turn on and press the

button again to turn the vacuum cleaner off.

(Fig.4/1)

Fig.4/1

Fig.4/2

Fig.4/3

Hard Floor Cleaning

For hard ﬂoor cleaning, press the rocker

switch on the combination ﬂoor head to lower

the brushes. (Fig.4/3)

Carpet Cleaning

For carpet and rug cleaning press the rocker

switch on the combination ﬂoor head to raise

the brushes. (Fig.4/2 )

Fig.4/4

Fig.4/5

Fig.4/6

Carry Handle

Use the carry handle located on the top of the

machine to move the vacuum cleaner from

room to room. (Fig.4/4)

Cable Storage

After use, turn the vacuum cleaner off and

unplug from the electrical outlet. Wrap the

cord around the cable storage hook for

moving the unit from room to room or for

storage. (Fig4/5)

Hose Storage

For convenience there is a parking slot located

on the side of the vacuum cleaner where the

ﬂoor tool and hose can be parked for carrying

and storage. (Fig.4/6)

Commercial User Guide.indd 4 5/10/07 11:12:21 AM

1 2 3 4

Comments to this Manuals

No comments