Vax VCC-07 User's Guide Page 1

Browse online or download User's Guide for Vacuum cleaner supplies Vax VCC-07. Vax VCC-07 User guide User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Vaxcare:
AUST: 1300 361 505
NZ: 0800 800 900
MODIFIED NOV 2007 P/N C-5410
www.vax.com.au
Instruction Manual
Please read carefully before using the cleaner.
Always fully extend the mains cable before use.
Workman
VCC-O5
VCC-07
10. Troubleshooting
WARNING: To reduce the risk of injury,
unplug the vacuum cleaner before servicing.
PROBLEM: Vacuum cleaner won’t run
Cause:
Not properly plugged into electrical outlet.
Solution: Plug unit in firmly.
Cause: Vacuum cleaner not turned on.
Solution: Press on/off button.
Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum
cleaner. Leave for one (1) hour. See page 2.
PROBLEM: Cleaner won’t pick up/
loss of suction
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and
replacement.
Cause: Dust bag full or blocked.
Solution: Replace dust bag. Empty/clean/
replace cloth bag
Cause: Clogged filter.
Solution:
Remove/replace with new filter VCC-05.
Remove wash/replace HEPA filter VCC-07.
Cause: Blockage in hose.
Solution: Disconnect hose, remove the
obstruction then re-fit.
PROBLEM: Accessories won’t pick up
Cause: Accessories are not attached correctly.
Solution:
Refer to page 5 for fitting information.
PROBLEM: Dust escaping from the
vacuum cleaner
Cause: Dust bag full.
Solution:
Dispose of paper dust bag, replace
with a new one or empty/clean/replace cloth bag.
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and
replacement.
Cause: Hose is not installed correctly.
Solution: Review hose installation.
Cause: Filter not installed completely.
Solution: Review filter removal and
replacement.
8. VAXCARE Service & Help:
AUSTRALIA 1300 361 505
NEW ZEALAND 0800 800 900
If you have any queries or concerns about
using your Vax, call VAXCARE. Please make
a note of the part number or model number
of the appliance before calling.
(Aust only: Mon-Fri. 8:30am - 5:30pm. EST)
Calls are charged at the local rate.
An answerphone is available outside of
these hours. We will return your call the next
working day.
There are over 300 approved Vax Service Agents
in Australia and New Zealand. For the nearest
Service Agent, please refer to your Vax warranty
or call VAXCARE or visit www.vax.com.au
9. Technical Specification
Voltage 220-240V~50Hz
Wattage: 1400W Model VCC-05
1500W Model VCC-07
Capacity: 6 litres max Model VCC-05
8 litres max Model VCC-07
Filters: Pre-motor filter VCC-05 only
HEPA Model VCC-07 only
Cord length: 12 metres
Weight: 7.2kg Model VCC-05
8.5kg Model VCC-07
Subject to technical change without notice.
12 Month VAXCARE Commercial Warranty
Commercial User Guide.indd 1 5/10/07 11:12:18 AM
Page view 0
1 2 3 4

Summary of Contents

Page 1 - Vaxcare:

Vaxcare:AUST: 1300 361 505NZ: 0800 800 900MODIFIED NOV 2007 P/N C-5410www.vax.com.auInstruction ManualPlease read carefully before using the cleaner.

Page 2 - 7. Clearing Blockages

2 71. Safety InstructionsFor Commercial Use OnlyWhen using the vacuum cleaner, basic safety precautions should always be observed, including

Page 3 - VCC-05 & VCC-07

Fig.6/3Fig.6/436VCC-05 & VCC-071 Hose inlet2 Top cover retainer clip3 Top cover4 Carry handle5 Power cord storage6 Parking slot7 Exhaust grill8 On

Page 4 - 4. How to Operate

3. How to AssembleFig.3/3Fig.3/2Fig.3/14 55. AccessoriesThe accessories can be attached directly to the handle by removing the extension tube

Comments to this Manuals

No comments