Vax VEC-21 User's Guide download pdf (Page 7)

Vax Careline 0870 606 1248

dirt container & filter / clearing blockages

Return the pre-motor filter to the vacuum cleaner and

close the vacuum cleaner lid.

Post-motor Filter

NOTE: This is located on the back of the vacuum cleaner.

Release the post-motor cover by pressing down on the

two catches at the top of the cover (Fig.6/9).

Remove the filter by pulling away from the casing

(Fig.6/10).

The post-motor filter can be rinsed in warm water (max

40°C). Allow to air dry for at least 24 hours before

replacing

Return the post-motor filter to the casing and re-fit to the

back of the vacuum cleaner.

7. Clearing Blockages

WARNING: To reduce the risk of electric shock,

the power cord must be disconnected before

performing maintenance or troubleshooting checks.

Turn the vacuum cleaner off and unplug from the electrical

outlet.

The flexible hose can be disconnected from the vacuum

cleaner by rotating 90 deg. Anti-clockwise, until the hose

lugs line up with spacers and then pull away from the

machine. Remove any blockages found then re-connect

the hose securely.

Removing debris from the TurboTool (

Model: VEC-02 only)

Switch the vacuum cleaner off and disconnect the power

plug from the electrical outlet.

Rotate the locking ring 180º (Fig.7/1).

Lift the top cover off and remove any blockage (Fig.7/2).

To re-assemble, ensure that the tabs are engage. Pivot the

lower housing closed and rotate the locking ring 180º

(Fig.7/2).

LOCKING RING

Fig.7/1

TABS

Fig.7/2

Fig.6/9

Fig.6/10

Vax VEC-01&02 User Guide.qxd 27/9/07 17:17 Page 7

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Vax VEC-21 User's Guide Page 7